Solution for Error Code 010-321 on Xerox Colour 550

The A system error has occurred 010-321 code of fuser unit, usually, fuser nip fail. First of all, check if there any obstructions inside the printer.

Xerox Colour 550 System Error code 010-321 Solve

Here in this post, I’m explaining How to fix the error A system error has occurred 010-321 in your Xerox colour 550 series copier. If your machine is under maintenance you should call them to have it replaced. This introduction will help you to troubleshoot the common error 010-321 on your Xerox colour 550, Xerox 250, Xerox 240, Xerox 252, Xerox 260, Xerox 7765, Xerox 7775 models. We are sharing few methods to fix the error, so check them one by one until it gets solved.

Fix 010-321 error code

The A system error has occurred 010-321 code of fuser unit, usually, fuser nip fail. First of all, check if there any obstructions inside the printer. The fuser has a nvm and you want to reset it. Then follow these steps.

  • Press and hold the zero (0) button for 5 seconds.
  • Then press the start button and dial the password 654321 and confirm it.
  • After this, you have to press the key button/log out button.
  • Then go to system settingscommon settingsmaintenance or diagnostic.
  • Then we will go to nvm read/write. Press 74435 on the chain link. Dial “0” on the new value column.
  • Then save and confirm it. Close it. Press the exit button. The machine will restart itself and code will be gone out.

If the problem persists

  • remove and reinstall the fuser unit.
  • Check the fuser connector.
  • Replace the fuser unit.

Find out the reason behind this error code in your copier, then replace that spare. If the problem persists again, it is better to call a Xerox Technician.

Tags

No responses yet

Leave a Reply

Your email address will not be published. Required fields are marked *

Categories